Dremel 4200 Especificações descarregar pdf (Página 9)

9

Always unplug Rotary Tool

before changing accessories,

changing collets or servicing your Rotary Tool.

After changing bits or

making any adjustments,

make sure the bit is properly secured by

pulling the EZ Change™ levers forward.

Loose adjustment devices can unexpectedly

shift, causing loss of control, loose rotating

components may be ejected.

INSTALLING AND REMOVING

ACCESSORIES

Your Dremel 4200 is equipped with the EZ

Change™ mechanism which will allow you to

quickly and easily change accessories without

the use of a wrench.

1. To install a accessory, pull and hold the EZ

Change™ levers in direction of arrows 1 as far

as they will go (Fig. 2).

2. Insert accessory into the collet as far as

possible to minimize runout and unbalance, and

then and release EZ Change™ levers.

3. Press EZ Change™ levers towards the nose

of the tool to fully secure the bit. If slipping of the

bit while in use occur, the tool needs service.

4. To remove accessories, pull and hold the EZ

Change™ levers in direction of arrows 1 as far

as they will go and simply remove accessory

from the EZ Change™ chuck.

Do not engage the EZ

Change™ levers while the

Rotary Tool is running as the bit may be

ejected.

COLLETS

Four different size collets to accommodate

different shank sizes, are avail able for your

Rotary Tool (Fig. 3).

Always use the collet which

matches the shank size of

the accessory you plan to use. Never force a

larger diameter shank into a collet.

Note: Most rotary tool kits do not include all four

collets sizes. Other collets sizes can be ordered

through the Dremel Service Center or on-line.

CHANGING COLLETS

To install a different collet, remove collet from

EZ Change™ chuck by using needle nose

pliers (Fig. 4). Lightly depress the finger of the

collet until it is clear of the detent feature

(Fig. 5) and pull collet free from chuck. Insert

Assembly

!

WARNING

!

WARNING

1

1

2

EZ CHANGE™

CHUCK

FIG. 2

EZ CHANGE™

LEVERS

ACCESSORY

COLLET

IDENTIFICATION

RINGS

1/8"

COLLET

3/32"

COLLET

1/16"

COLLET

1/32"

COLLET

FIG. 3

COLLET IDENTIFICATION CHART

Collet sizes can be identified by the rings

on the back end of collet.

1/32" Collet has one (1) ring.

1/16" Collet has two (2) rings.

3/32" Collet has three (3) rings.

1/8" Collet has no rings. 1/8" is included

in the 4200 kit.

!

CAUTION

!

CAUTION

NEEDLE

NOSE

PLIERS

COLLET

FIG. 4

EZ CHANGE™

CHUCK

COLLET

DETENT

DETENT

Push collet finger with needle nose pliers

until clear of detents and then pull it out

FINGER

FIG. 5

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 75 76

Comentários a estes Manuais

Sem comentários